DeWalt D55152 Manual De Instrucciones página 7

WHAT CAN HAPPEN
• Failure to properly drain
condensed water from
air tank, causing rust and
thinning of the steel air tank.
• Modifications or attempted
repairs to the air tank.
• Unauthorized modifications
to the safety valve or any
other components which
control air tank pressure.
Attachments & accessories:
• Exceeding the pressure
rating of air tools, spray
guns, air operated
accessories, tires, and other
inflatables can cause them
to explode or fly apart, and
could result in serious injury.
HOW TO PREVENT IT
• Drain air tank daily or after
each use. If air tank develops
a leak, replace it immediately
with a new air tank or replace
the entire compressor.
• Never drill into, weld, or make
any modifications to the
air tank or its attachments.
Never attempt to repair a
damaged or leaking air tank.
Replace with a new air tank.
• The air tank is designed
to withstand specific
operating pressures. Never
make adjustments or
parts substitutions to alter
the factory set operating
pressures.
• Follow the equipment
manufacturers
recommendation and never
exceed the maximum
allowable pressure rating
of attachments. Never use
compressor to inflate small
low pressure objects such
as children's toys, footballs,
basketballs, etc.
WARNING: RISK OF ELECTRICAL SHOCK
WHAT CAN HAPPEN
• Your air compressor is
powered by electricity.
Like any other electrically
powered device, If it is not
used properly it may cause
electric shock.
• Repairs attempted by
unqualified personnel can
result in serious injury or
death by electrocution.
• Electrical Grounding:
Failure to provide
adequate grounding to
this product could result
in serious injury or death
from electrocution. See
Grounding Instructions
under Installation.
7
HOW TO PREVENT IT
• Never operate the
compressor outdoors
when it is raining or in wet
conditions.
• Never operate compressor
with protective covers
removed or damaged.
• Any electrical wiring
or repairs required on
this product should be
performed by a D WALT
e
factory service center or a
D WALT authorized service
e
center in accordance with
national and local electrical
codes.
• Make certain that the
electrical circuit to which the
compressor is connected
provides proper electrical
grounding, correct voltage
and adequate fuse
protection.