Publicidad
Idiomas disponibles
Idiomas disponibles
GETTING STARTED
Note: All images in this instruction manual are for indication only;
the physical appearance and options on your model may vary.
SERIAL AND MODEL NUMBER
Please record your model number and serial number below.
You can find the number plate on the outside rear of the refrig-
erator.
Model Number: ______________________________
Serial Number: ______________________________
Date of Purchase: ____________________________
BEFORE DISCARDING YOUR OLD REFRIGERATOR:
•
Remove the door(s), leave the shelves in place (to help pre-
vent children from crawling in) and have it removed from
your premises by a qualified technician.
•
Check with your retailer to find out if they'll take away and
responsibly dispose of or recycle your old refrigerator.
•
See www.epa.gov/rad for more information on Responsible
Appliance Disposal.
SAFETY NOTICES
This appliance is intended to be used in household and similar
applications such as:
•
Staff kitchen areas in shops, offices and other working en-
vironments;
•
Individual use in hotel rooms and other residential type en-
vironments;
INSTALLING YOUR APPLIANCE
UNPACKING YOUR REFRIGERATOR
1. Remove all packaging material. This includes the foam
base and all adhesive tape holding the refrigerator acces-
sories inside and outside.
2. Inspect and remove any remains of packing, tape or print-
ed materials before powering on the refrigerator.
CAUTION: Risk of Fire or Explosion due to puncture of refrig-
erant tubing. Flammable refrigerant used. Handle with care
when moving refrigerator to avoid either damaging the refrig-
erant tubing or increasing the risk of a leak.
LOCATION
When selecting a position for your unit, ensure the floor is a flat,
level surface and the room is well ventilated. Avoid locating your
unit near a heat source, such as an oven, stove top, boiler, or ra-
diator. Also avoid direct sunlight as it may increase the electrical
consumption.
Extremely cold ambient temperatures may also prevent the unit
from operating effectively. This unit is not designed for use in a
garage or outdoor installation. Do not place any covering such
as a drape or sheet on the unit.
When installing the unit, ensure that a minimum of 4 inches of
free space is left at both sides and in the rear, and 4 inches of
space at the top of the unit. This will allow cold air to circulate
around the refrigerator and improve the efficiency of the cool-
ing process.
Do not install your refrigerator in any location not properly in-
sulated or heated, e.g. garage, etc. Your refrigerator was not
designed to operate in temperature settings below 12 degrees
Celsius.
LEVELING THE UNIT
It's very important to keep the unit level, so that the door will
close properly and prevent problem that will cause effective
cooling to fail. To level the unit, turn the two adjustable feet at
the front base of the refrigerator clockwise or counterclockwise
to respectively raise or lower the corner.
Tip: Having someone push against the top of the refrigerator will
take some weight off the leveling leg. This makes it easier to ad-
just the leveling leg.
CLEANING BEFORE USE
Wipe the inside of the unit with a weak solution of baking
soda (bicarbonate). Then rinse with warm water using a damp
sponge or cloth. Wash the shelves and bins in warm soapy water
and dry completely before putting back in the unit.
Note: This unit is shipped with a protective plastic-wrap
around the exterior. Remove completely before use.
POWER SUPPLY
•
Be sure to plug in to suitable power outlet (115 volts, 15
amps outlet) grounded outlet.
•
You must make sure all three prongs are in a 3-pronged
outlet.
Notes: When plugging in to wall, it should have a dedicat-
ed outlet.
GROUNDING INSTRUCTIONS
This appliance must be grounded. This is accomplished by
ensuring the plug is inserted into a properly grounded outlet.
This way, in the event of an electrical short circuit, the risk of
electric shock is reduced by providing an escape wire for the
–5–
Publicidad
