Federal Signal Corporation AM50-70B Instrucciones De Instalación página 5

D. TESTING/OPERATING.
Under certain conditions these devices are capable of producing sounds loud
enough to cause hearing damage. Adequate hearing protection should be worn if
standing within close proximity to device while testing. Recommendations in the
OSHA Sound Level Standard (29 CFR 1910) should not be exceeded.
1. After installation is complete, be sure to test the system to verify that each speaker
operates satisfactorily. If it is found that the volume is too low for its location, a higher
wattage tap may be selected. Carefully remove the speaker and move the jumper to a higher
wattage tap (see figure 2). Reinstall the speaker and retest.
2. After completion of initial system test, establish a program for periodic testing of
this device. Refer to NFPA 72, local Fire Codes and the authority having jurisdiction for this
information.
3. Provide a copy of these instructions for the Safety Engineer, system operator(s)
and maintenance personnel.
Even if your warning system is operating properly, it may not be completely
effective. People may not see, hear or heed your warning signal. You must
recognize this fact and ensure that your warning signal achieves its intended effect
through proper testing/training sequences within your specific application(s), or
other appropriate actions.
E. MAINTENANCE.
If cleaning of the Model AM50's front face is required, a mild soap solution is recom-
mended as the cleaning agent.
Although not advised, if painting/touch-up of the grille model's vinyl face is
necessary, a vinyl-based paint is required for coverage.
Failure to follow all safety precautions and instructions in this document may result in
property damage, serious injury, or death to you or others.
• Read and understand all instructions before performing maintenance on this
unit.
• Periodic checks should be made to ensure that effectiveness of this device has
not been reduced because speaker has become clogged with a foreign
substance or because objects have been placed in front of the speaker.
• Any maintenance to this unit MUST be performed by a trained electrician in
accordance with NEC guidelines and local codes.
• Never alter this unit in any manner.
1. Periodically check this device to verify that there are no foreign substances in, or
in front of, the speaker which will reduce its effectiveness.
SAFETY MESSAGE TO OPERATORS
SAFETY MESSAGE TO MAINTENANCE PERSONNEL
NOTE
-3-