Onkyo TX-RZ610 Manual Básico página 24

> Before start > Hookup
the main room and separate room with the AM/FM
radio. When you select an input or station for the
separate room, the main room also switches.
0 DSD and Dolby TrueHD audio signals are not output
to ZONE 2 when selected with the "NET" input
selector.
4. To adjust the volume on this unit, adjust with VOL+/– on
the remote controller. To control on the main unit, press
ZONE 2 and adjust with the MASTER VOLUME control
within 8 seconds.
0 If ZONE 2 is on, power consumption during standby
becomes larger than normal.
To turn off the function
Press Í while in the mode for controlling ZONE 2 on the
remote controller.
Playing in ZONE 2 only
If you turn the unit to standby during multi-zone playback,
the Z2 indicator is dimmed and the playback mode is
switched to playback in a separate room only. Setting
ZONE 2 to on while this unit is in standby will also switch
the playback mode to the same setting.
24
> Setup > Playback
Others
To adjust the sound quality
It is possible to enhance or moderate the bass and treble of
front speakers. Press TONE on the main unit several times
to select the desired setting from "Bass" and "Treble", and
turn the TONE dial to adjust. You can adjust the sound
quality of the connected power amplifier when you turn
ZONE 2 on.
Quick Menu
By pressing Q on the remote controller during play, you can
adjust frequently used settings, such as the sound quality,
using on-screen menus. Select the item with the cursors of
the remote controller and press ENTER to confirm your
selection. To return to the previous screen, press
Quick Menu
Tone Bass
Level Treble
AccuEQ
Other
0 You can adjust the sound quality with "Tone". "Other"
includes settings such as "A/V Sync" that allows you to
adjust the audio delay when the video is behind the
audio, "Music Optimizer" that provides better sound
quality for compressed audio, and "HDMI Out" which
allows you to select the HDMI OUT terminal to output
from.
> Part Names
When the unit is operating erratically
(Resetting the unit)
Restarting the unit may help it operate more smoothly. To
restart the unit, turn it to standby, and then press Í ON/
STANDBY on the main unit for at least 5 seconds. (The
unit's settings will be maintained.) If there is no
improvement even after the unit is restarted, try
disconnecting and reconnecting the power cords of the unit
and connected equipment. When there is still no
improvement, resetting the unit to the status at the time of
shipment may solve the problem. If you reset the unit
status, your preferences will be reset to the defaults. Note
them down before the operation below.
.
How to reset the unit
1. While holding down CBL/SAT on the main unit, press
Í ON/STANDBY on the main unit.
BD/DVD
2. "Clear" appears on the display and the unit returns to
standby. Do not unplug the power cord until "Clear"
disappears from the display.
To reset the remote controller, while holding down MODE,
press until the remote indicator flash twice (about
3 seconds).