ADURO 12 Manual De Usuario página 34

Aduro 15 Lux The stove leaves the factory with the flue outlet mounted on the top. If you require the
flue outlet on the back, break off the cover plates positioned at the top of the back of
the stove. Exchange the exhaust connector (from the top outlet) with the cover plate
from the rear outlet. Mount the cover plate from the rear outlet to the top outlet. The top
outlet is finished with the plate that lies in the ashpan. You may benefit from putting a
slim gasket between the flue on the stove and the flue pipe.
Aduro 12 The stove leaves the factory with the flue outlet mounted
on the top. If you require the flue outlet on the back, please
take of the plate behind the flue outlet, turn it around (see
illustration) and then switch the smoke outlet (sitting at the
top flue outlet) with the cover plate (which covers the
smoke outlet on the back of the stove). The top outlet is
finished with the plate that lies in the ashpan. If you require
the flue outlet on the back, Aduro offers special flue pipes.
You may benefit from putting a slim gasket between the
flue on the stove and the flue pipe.
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney you should use the rear outlet or a curved flue pipe via the
top outlet. After measuring, a hole is made in the chimney in which the pipe sleeve is placed, and stove
mortar is used to seal it in place. The stove is placed in position, and the flue pipe is put in place. A thin
gasket is placed between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude
into the pipe sleeve but must not block the opening in the chimney (see the illustration below). You may
benefit from putting a slim gasket between the flue on the stove and the flue pipe.
The stove can be connected to a chimney to which other heat sources are connected.
34