Cebora 456 Manual De Instrucciones página 15

This manual is part of the overall documentation and is invalid unless it is used in conjunction with the
following parts of the documentation that you can consult in the Support-Documentation section of the
website welding�cebora�it:
3301151 General warnings
3301291 Instruction manual MIG power sources
3301286 Instruction manual TIG power sources
IMPORTANT - Before using this device, read the instructions in this manual and in General Warnings manual code
3301151 carefully and make sure you understand them.
Always keep this manual at the place where the device is used.
The equipment can only be used for welding or cutting operations. Do not use this device to charge batteries, defrost
pipes or start motors.
Only expert staff can install, operate, maintain and repair this device. An expert staff member means someone who
can judge the work assigned to them and recognise possible risks based on their vocational training, knowledge and
experience.
Liability regarding system operation is expressly limited to the system's function. Further liability of any kind is
expressly excluded.
Any use that differs from what is expressly indicated and is implemented in different ways or contrary to what is
indicated in this publication amounts to improper use. The manufacturer declines any liability arising from improper
use that may cause accidents to people and possible system malfunctions.
This exclusion of liability is acknowledged upon commissioning of the system by the user.
The Manufacture is unable to monitor compliance with these instructions or device installation, operation and use, and
maintenance conditions and methods provided in General Warnings manual code 3301151.
Observe the accident prevention regulations and the regulations in force in the country of installation (for example IEC
EN 60974-4 and IEC EN 60974-9).
Inappropriate execution of the installation may lead to material damage and consequently to personal injury. Therefore,
no liability is assumed for loss, damage or cost arising out of or in any way connected with improper installation,
incorrect operation or inappropriate use and maintenance.
The manufacturer therefore disclaims all liability for malfunctions or damage to its welding/cutting power sources and
system components resulting from improper installation.
The welding or cutting power source complies with the regulations set out on the power source technical data plate.
Use of the welding or cutting power source built into automatic or semi-automatic systems is permitted.
The system installer is responsible for checking the complete compatibility and correct operation of all components
used in the system.
It is forbidden to connect two or more power sources in parallel without the prior written authorisation of the
manufacturer, which will determine and authorise the procedures and conditions for the required application in
compliance with current product and safety regulations.
© CEBORA S.p.A.
The copyright of these operating instructions is owned by the manufacturer.
The contents of this document may be subject to change.
Copying and reproduction of its contents and illustrations in any form and using any medium is prohibited.
The contents and illustrations of this document may not be redistributed or published without the prior written
authorisation of the manufacturer.
3301307 3301291 15