Publicidad
Idiomas disponibles
Idiomas disponibles
container must be carried out only by the manufacturer or authorized representative, who
should be contacted if oil leaks from the heater.
23.
If disposing of the heater please follow rules of oil disposal.
WARNING: To avoid overheating do not cover the heater.
DESCRIPTION OF THE DEVICE (Fig. 1)
1.
Diode indicating operation of the device
2.
Thermostat control knob
3.
On-switch control knob
4.
Cable storage
5.
Wheels
6.
Ribs
ASSEMBLY (Fig. 2)
1.
Turn the heater upside down.
2.
Place the wheel bases between the last ribs.
3.
Use the U-shaped clamp to hook the bases.
4.
Block the clamp by screwing on the butterfl y nut.
5.
Place the heater on the wheels.
CAUTION: After turning the heater, wait at least one hour before connecting it to a power outlet.
USING THE DEVICE
CAUTION: During fi rst use of the heater a small amount of smoke may appear. This is normal.
1.
Place the oil heater a minimum of 100 cm from walls, furniture, curtains, plants etc.
2.
Make sure that the on-switch control knob (3) and thermostat control knob (2) are set to '0' .
Connect the oil heater to mains power.
3.
Turn the heater on by turning the on-switch control knob (3) to position 1 (low heating
power) or 2,3 (high heating power). Set a comfortable oil heater temperature by turning the
thermostat control knob.
4.
After you fi nish using the heater, turn it off by turning the on-switch control knob and
thermostat control knob to '0' and disconnect the power cable from mains power.
CLEANING THE DEVICE
1.
Prior to cleaning always remove the plug from the electrical outlet.
2.
Prior to cleaning allow the heater to cool. Make sure that it is cool.
3.
Wipe the heater with a damp cloth, then wipe dry.
4.
Never use wax, shining agents or chemical agents to clean the heater. They may react with
the device and cause discoloration or even damage.
TECHNICAL DATA
Power source: 220-240 V~50 Hz
Power: BP1011 – 1: 1: 1000 W 2: 1500 W 3: 2500W
Device is made in class I of insulation and has to be
connected only to power outlet with ground circuit.
Device is compliant with EU directives:
•
Low voltage directive (LVD)
•
Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
2
3
1
4
6
5
EN
7
Publicidad
