Descargar Imprimir esta página

Blaupunkt BP1004 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

PLEASE READ THE INSTRUCTIONS CAREFULLY OF THIS
MANUAL BEFORE STARTING.
DO NOT HANDLE THE QUARTZ HEATER INTERNALLY.
The texts, photos, colors, figures and data correspond to the current technical level
from the moment they were printed. We reserve the right to modifications
motivated by the permanent development of the technique in our products
TECHNICAL SPECIFICATIONS BP1004
Maximum Power: 400 + 400 W
The rated power: 220 - 240 V ~
Frequency: 50/60 Hz
FRONT NAME OF THE PARTS OF THE HEATER
1.
Ignition switches top tube
EN
2.
Tube power button lower.
3.
Heater body.
4.
Protective grid.
5.
Reflector.
GENERAL INFORMATION
Before putting the appliance into operation, read the following instructions carefully.
KEEP THIS BROCHURE IN A SAFE PLACE SO YOU CAN SEE IT ANYWHERE MOMENT INSTALLATION
This stove does not need installation, because it is a portable appliance.
These portable electric heating devices are not recommended for use in the bathroom.
Place the unit on a flat and unobstructed surface, plug the power cord into a electricity from your
home.
FUNCTIONING
1.
Verify that your home voltage matches that of the quartz stove.
2.
Plug the power cord into the power outlet.
3.
Press the switch (1) to start the upper quartz tube on the stove. The other switch (2) will start
the other tube, whenever this stop the two switches must be in position OFF.
4.
After use, turn all switches to the OFF position and unplug the appliance.
ELECTRIC CONNECTION
Before connecting the appliance, make sure that the specifications on the data plate correspond to
the conditions of the electricity supply network.
The electrical safety of this appliance is only ensured if it has been properly grounded.
This device complies with the 89/336 / CEE directives related to electromagnetic interference.
WARNING
We strongly recommend that it be used in a safe electrical installation.
Do not install the appliance very close to bathtubs, showers, toilets, swimming pools, etc.
This appliance is intended for the use specified by the manufacturer, which is to heat an area. Any
other use will be incorrect and therefore dangerous.
The manufacturer is not responsible for damage caused by improper and unreasonable use of this
appliance.
DO NOT COVER THE APPLIANCE WITH ANY OBJECT AS IT COULD IGNITE DURING YOUR USE.
Children and older people with little knowledge of electrical appliances should have a higher
caution.
This device is not intended for use by persons (including children) with physical sensory abilities or
mental, or lack of experience and knowledge, unless they have been supervised or instructed about
the use of the device by a person responsible for your safety Do not put accessories or equipment on
the appliance that are not provided by the manufacturer. The wrong installation If the power cable
6

Publicidad

loading