Publicidad
Idiomas disponibles
Idiomas disponibles
!!WARNING! Before using the machine, in order to ensure that handling, initial start-up, starting, use, stopping, and maintenance
are carried out properly, read the instructions below that refer to the drawings and technical data and apply them carefully.
Before starting work you should be familiar with the controls and the correct use of this machine, making sure that you know how
to stop it in the event of an emergency. Incorrect use of this machine may result in serious injury and damage to property. Always
consider your safety and the safety of others and act accordingly.
!! WARNING! The machine is exclusively intended for DIY use and it is suitable for making longitudinal, tilted and slanted cuts on
rectangular parallelepiped shaped wood. Cutting metal, plastic, fabric, ammable materials and materials that generate harmful
or toxic dust and vapours is prohibited. Any use other than that indicated in these instructions may damage the machine and
constitute a serious risk to both people and property.
TRANSPORT AND LIFTING
!!WARNING! The manufacturer is not liable for any direct and/or indirect damage caused by incorrect transport or lifting.
The machine must be transported and lifted with caution to avoid accidents and damage.
1) Position the blade so that it is completely retracted inside the machine.
2) Lift the machine with extreme caution, holding it with both hands under the base and moving it slowly, without jerky or
sudden movements.
Do not attempt to move the machine by pulling it by the power cable or other machine parts.
STARTING UP
!!WARNING! The manufacturer is not liable for any direct and/or indirect damage caused by incorrect installation or connections.
!!WARNING! Before carrying out the following operations, make sure that the machine's plug is disconnected from the mains.
The machine is supplied with some disassembled components and before using it, it must be cleaned and installed.
When choosing where to put the machine, the following should be considered:
- That the planned position is not damp and is protected from the elements.
- That the area where it will be placed is completely at, on a non-slip oor and with appropriate load capacity.
- That there should be a large operational area around the machine free from obstacles.
- That the room should be attended and closed in order to prevent free access.
- That there is good lighting.
- That it needs to be positioned close to the general di erential switch.
- That the room temperature should be between 10° and 35° C.
- That the work environment is not in an explosive atmosphere.
Make sure that all the parts have been properly and securely assembled and that the machine is stable before starting it.
STARTING AND STOPPING
!!WARNING! Before starting the machine it is compulsory to put on goggles, gloves, headphones and dust mask (not provided
with the machine).
!!WARNING! Whilst starting and stopping, make sure that nobody approaches the machine. Keep safety distance from all moving
parts and from the cutting area.
!!WARNING! The motor, the moving parts and the blade continue to run for a short while after the machine is switched o . During
this time, these parts must not be touched. Serious injury hazard!
Before starting the machine check the integrity of all the components and that all the bolts and couplings are tight.
STARTING UP
1) Make sure service keys are inserted.
2) Insert the power cable plug into the socket.
3) Stand alongside the machine and ensure that all people and animals are far away.
4) To start press the ON 'I' switch (switched on).
If you notice any working defects, switch o the machine and consult the chapter "troubleshooting and permitted operations".
11
www.ELITETOOLS.co
Keep Working
Publicidad
