Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
!!WARNING! Before conducting checks or maintenance, turn the switch to OFF "O" and unplug the machine from the electric
power supply.
!!WARNING! Do not tamper with or attempt to repair motor or electrical parts.
Machine working life and costs also depend on constant and meticulous maintenance. Always observe the following
instructions.
CLEANING AFTER USE
- Routinely clean and care for your machine to ensure that it remains perfectly e cient and has a long working life.
- Remove sawdust using a soft brush and vacuum; take scrap material to a recycling centre.
- Remove any traces of resin that stick to the machine.
- Do not spray or soak the machine with water.
- Do not use any in ammable substances, detergents or solvents as these may damage the machine beyond repair. The plastic
parts can easily be damaged by chemical agents.
- Do not use compressed air for cleaning: Risk of ying chips and splinters!
- Pay the utmost attention when cleaning switches, hand grip, engine fan slots, blade, control levers, rotary table, the base, rotary
table inserts and the saw bench.
For your safety, periodically check the conditions of the following components. Replace them if damaged or worn:
- Switches
- Blade
- Guards
- Piece guide
- Exhaust manifold
- Insert/panel of work surface
- Power supply plug and cable
MOTOR BRUSHES (where tted)
The motor of this machine may be of the manifold type that is equipped with a pair of graphite brushes. The brushes must be
inspected and replaced by an authorised assistance centre.
TROUBLESHOOTING AND PERMITTED OPERATIONS
THE MACHINE DOES NOT START OR IT STOPS AND DOES NOT RESTART:
No power:
- Make sure the power cable and extension (if applicable) are not damaged.
- Check the power supply system's main switch.
Circuit breaker tripped (if applicable):
- Press the reset button.
Worn graphite brushes (if applicable):
- Contact an authorised assistance centre.
Electrical fault:
- Contact an authorised assistance centre.
THE BLADE DOES NOT LIFT/LOWER OR DOES NOT TILT (where these functions are tted)
Lever/handwheel locked:
- Loosen the handwheel.
Cutting residuals inside the machine that prevent movement:
- Contact an authorised assistance centre.
www.ELITETOOLS.co
Keep Working
15
Publicidad
