Publicidad
Idiomas disponibles
Idiomas disponibles
S
Height range
setting
Restore
S
factory
settings
Unit
S
conversion
Press and hold the
When the LED displays "HLP",
release the
moment, the LED flashes and
displays "HLP" and the current
height value. At the moment,
the current height value can be
adjusted by the
1. Press the number key
and the LED will flash and
display "H-P". At the moment,
pressing the
not respond. You can only press
Long press
S
the
key to save the current
for 6s
value.
2. Press the number key
and the LED will flash and
display "LH-P". At the moment,
pressing the
not respond. You can only press
S
the
key to save the current
value.
3. Press the number key
directly delete the set maximum
and minimum heights.
Long press the
it when the LED screen displays
Long press
"FAC", and press it again to
for 9s
restore the factory settings.
Long press the
when the LED screen displays
"SET", and press the numeral
Long press
key
1
to start unit conversion
for 3s
setting. At this time, "unt" and
the current height value alter-
nately flash on the LED screen.
Adjust the unit by the
key, and press the
save the current setting.
S
key.
S
key. At the
or
keys:
,
1
or
keys will
2
,
or
keys will
3
to
S
key, release
S
key, release it
or
S
key to
1. If you do not press the
key within 15s after "HLP"
and the current height value
start flashing alternately on
the LED screen, you will quit
this setting mode.
2. When "HLP" and the
current height value
alternately flash on the LED
screen, the current height
value must be adjusted by
pressing the
or
3. When "HLP" and the
current height value
alternately flash on the LED
screen, press the numeral
3
key
to delete the saved
maximum and minimum
heights.
1. If you do not press the
key within 15s after "FAC"
starts flashing on the LED
screen, you will exit / quit the
setting mode.
2. When the factory settings
are restored, existing
memory position, height
range, sensitivity and unit
will be erased.
3. After the factory settings
are restored, they will be
displayed (including 3
memory positions, sensitivity,
and unit)
1. When "unt" and the
current height value
alternately flash on the LED
screen, if you do not press
S
the
key for confirmation
after adjusting the unit by the
or
key, the system will
automatically save the
current unit setting after 15s.
S
key.
S
26
Publicidad
