Worx WX718 Manual Original página 11

NOISE INFORMATION
WX718.X
A weighted
L : 83,6 dB(A) LpA: 83.7 dB(A)
sound pressure
pA
A weighted
L : 94,6 dB(A)
sound power
wA
K &K
pA wA
Wear ear protection
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
Vibration
surface emission value
grinding a
Grinder
h,AG
m/s
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
Angle Grinder
WX718 WX717
WX717.X
LwA: 94.7 dB(A)
3.0 dB
WX718 WX717
WX718.X WX717.X
Vibration
emission value
= 4,320 a = 4.106
h,AG
m/s
2 2
over the total working period.
Help to minimize your vibration exposure risk.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Avoid using tools in temperatures of 10
Plan your work schedule to spread any high vibration
tool use across a number of days.
4.INTENDED USE
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.
5.OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY AND OPERATION
Action
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting
Disc
REPLACING DISC
NOTE: Before any work on the machine itself, pull
the mains plug. For work with grinding or cutting
discs, the protection guard must be mounted.
Removing the disc by following the
reverse steps of Fig. B1,B2,B3.
Removing the wheel guard.
C or less
0
Figure
11
See Fig. A
See Fig.
B1,B2,B3
See Fig. C1,
C2(For WX718
WX718.X)
See Fig. D1,
D2(For WX717
WX717.X)
EN