Worx WX718 Manual Original página 12

Repalcing the wheel guard.
NOTE: The coded projection on
the wheel guard ensures that only
a guard that fits the machine type
can be mounted.
NOTE: Place the wheel guard
with coded projection into the
coded groove on the spindle of
the machine head and rotate to
the required position (working
position). The closed side of the
wheel guard must always point to
the operator.
NOTE: To fasten the wheel guard
by closing the clamping lever (For
WX718 WX718.X), or tightening
the screw(For WX717 WX717.X).
Repalcing the disc.
OPERATION
Plugging in the Power
Using On/Off Switch
Hand Grip Areas
Rough Grinding
WARNING! Never use a
cutting disc for roughing.
12
Cutting
WORKING HINTS FOR YOUR
ANGLE GRINDER
. Always start at no load to achieve maximum
1
speed then start working.
2. Do not force the disc to work faster, reducing the
Disc's moving speed means longer working time.
3. Always work with a 15-30 angle between disc and
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4. When using a cutting disc never change the
cutting angle otherwise you will stall the disc
and angle grinder motor or break the disc. When
cutting, only cut in the opposite direction to the
disc rotation. If you cut in the same direction as
the disc rotation the disc may push itself out of
the cut slot.
5. When cutting very hard material best results can
be achieved with a diamond disc.
6. When using a diamond disc it will become very
hot. If this happens you will see a full ring of
sparks around the rotating disc. Stop cutting and
allow to cool at no load speed for 2-3 minutes.
Angle Grinder
7. Always ensure the workpiece is firmly held or
6.MAINTENANCE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
TROUBLESHOOTING
See Fig. E
Although your new angle grinder is really very simple
See Fig. F
to operate, if you do experience problems, please
See Fig. G
check the following:
1. If your grinder will not operate check the power at
2. If your grinder wheel wobbles or vibrates, check
See Fig. H
3. If there is any evidence that the wheel is
4. If working on aluminum or a similar soft alloy,
7.ENVIRONMENTAL
PROTECTION
Local Authority or retailer for recycling advice.
clamped to prevent movement.
the main plug.
that outer flange is tight; check that the wheel is
correctly located on the flange plate.
damaged do not use as the damaged wheel may
disintegrate, remove it and replace with a new
wheel. Dispose of old wheels sensibly.
the wheel will soon become clogged and will not
grind effectively.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
EN