Publicidad
General information
Power connection
1. Connect the power supply to the camera charging port (9), using the
included power adapter.
2. Put the power adapter (DC12V/1A) into a power outlet.
MicroSD card
To insert the MicroSD card you need to remove the two screws and open
the compartment on the bottom of the camera.
After inserting the MicroSD card with the notches facing left, as seen in the
picture, close the compartment again using the screws.
Note: Take care while inserting the MicroSD into the slot. Otherwise it
could happen that you put the MicroSD into the device instead of into the
MicroSD slot.
Supports MicroSD card for local storage (max. 128GB). To guarantee the
normal use of MicroSD card, before insert the MicroSD card, make sure its
file system is FAT32 for 4-32GB and exFAT for 64-128GB. Check if there
is more than 256MB space available.
For 64-128GB MicroSD cards it might be necessary to format the MicroSD
card after inserting and configuration via the App. To work properly, the
App must show the following status under device memory: Normal.
IR LED
The device activates the infrared light automatically as soon as low
illumination prevails. There for the light option in the app needs to be set to
infrared. With the IR LEDs shining at night you get black/white
images/recordings at night.
White LED
The device activates the white light automatically as soon as low
illumination prevails. There for the light option in the app needs to be set to
8
Model: TX-192 Article No. 4991, 07/2022
Publicidad
