Publicidad
Idiomas disponibles
Idiomas disponibles
4. INSPECTING AND HANDLING THE UNIT
At delivery, the package should be checked and any damage should
be reported immediately to the carrier claims agent.
When handling the unit, take into account the following:
Fragile, handle the unit with care.
1
Choose on before hand the path along which the unit is to be
2
brought in.
Move this unit as originally package as possible.
3
4
When lifting the unit , always use protectors to prevent belt
damage and pay attention to the position of the unit's centre
of gravity.
5. INDOOR UNIT INSTALLATION
5.1 Installation place
Before installing the unit,be sure to confirm with the user
whether there are wires,water pipes,air pipes and so on in
the wall or ground of the installation site to avoid accidents
due to damage.
Installation in the following places may cause trouble.If it
is unavoidable, please consult with the local dealer.
A place full of machine oil.
A saline place such as coast.
A place full of sulfide gas such as hot-spring resort.
Places where there are high frequency machines such
as wireless equipment, welding
Machine, and medical facility.
A place there is no combustive gases and volatile matter.
A place of special environmental conditions.
Indoor Unit
A place where is no obstacle near the inlet and outlet area.
A place which can bearf the indoor unit.
A place which is convenient to maintenance.
A place which provides the space around the indoor unit as
required right in the diagram.
There is strong electromagnetic wave exist-ing.
A place which is far from heat, steam and inflammable gas.
5.2 Drilling A Hole and Mounting Installation
Board
Installation Board and Its Direction (unit: mm)
250\300\400 type
mounting board of indoor unit
462
712
915
the shape of indoor unit
installation manual
4
500\600 type
the shape of indoor unit
1
Fix the installation board.
It is recommended to install insulation between mounting board
and wall to avoid wall getting damp.
Install the installation board horizontally on structural parts in
the wall with the spaces provided around the plate.
In case of brick, concrete or similar type walls,make 5mmdia,
holes in the wall. Insert clip anchors for appropriate mounting
screws.
Fix the installation board on the wall.
Right installation
False installation
2
Drilling a hole.
Determine the pipe hole position using the installation
board , and drill the pipehole (N95mm) so it slants slightly
downward.
Always use a wall hole conduit when piercing metal lath,
ply wood or metal plate.
Fig.5-1
mounting board of indoor unit
730
794
1070
mounting board
of indoor unit
mounting board
of indoor unit
horizontal line
Fig.5-2
unit
mounting board
insulation
wall
Fig.5-3
horizontal line
Fig.5-4
mounting board
of indoor unit
Fig.5-5
Publicidad
