VONROC HF502AC Traducción Del Manual Original página 6

EN
• Place the humidifier away from furniture and
other electrical appliances and avoid spraying
the mist directly on the furniture or other
electrical appliances to make them damp.
• It is strictly forbidden to use the humidifier in
an environment with flammable and explosive
gases.
• Do place the humidifier near open flames and
heat sources, such as stoves, ovens, radiators
or computers.
• Do not place the humidifier in direct sunlight.
• To prevent interference and damage to other
electronic devices, this machine should be
placed at least 1 meter away from a computer,
television, radio or other electronic equipment.
• The humidifier should be placed in a normal
indoor temperature environment to avoid damage
of humidifier.
• This humidifier is only for indoor use.
• Put your humidifier in relatively easy access
areas. Place it where you can actually attend to it
if servicing is necessary. Make sure to clean your
humidifier frequently. Change the water regularly
because if you do not do that, chances of the
bacteria can grow inside the water that will
vaporize in the air and can lead to some serious
health problems.
• Maintain the indoor humidity level and avoid
going over 60%, ideally between 40-60%, if
possible. There are some instances that which
humidity or dampness in the air can produce
enough moisture for molds and mildew to grow.
Setting up the remote control
Pull the plastic film from the battery compartment
(Fig. F). The battery is now active and you can use
the remote control.
Changing the battery (Fig. G)
1. Push the release button inwards and pull the
battery casing out. Remove the old battery.
2. Insert 1x CR2025 3V battery into the battery
casing ensuring you follow the polarity (+ and -)
marking on the casing.
3. Slide the battery casing back into the remote
control unit. You hear it click firmly into place.
Starting the humidifier
1. Lift up the mist nozzle (6), aroma oil tray (5) and
water tank cover (4) from the water tank (3).
Separate the base from the water tank (Fig. A).
6
2. In the base, remove the foam packaging (9)
from the float ball (Fig. C).
3. Place the water tank (3) on the base (2).
4. Push the filter (7, optional) into the filter slot in
the bottom of the water tank (Fig. B).
5. Fill the water tank (3) with clean water (no
warmer than room temperature). The tank takes
approximately 4.5L of water.
NOTE: We recommend to use distilled water to
prevent the buildup of scale that will occur if
tap water is used.
6. Put the water tank cover (4) and mist nozzle
(6) back onto the water tank (3). Wipe off any
excess water from the exterior.
NOTE: If the humidifier has been stored in a
particularly cool place i.e. below 5°C, wait 30
minutes to warm up before tuning it on.
Using the humidifier (Fig. D)
1. Connect the power cable to a socket outlet.
2. Touch the ON/OFF button (15) to turn on the
humidifier. Every time you turn on the humidifier,
the default level mist will turn on and the current
room humidity will display.
3. Touch the Mist button repeatedly to select one
of the mist settings:
Display indicates
NOTE: When you are in setting mode the display
flashes. To confirm a setting, touch any button for a
few seconds and the display will stop flashing.
4. Touch the humidity button (16) repeatedly to
select the humidity level from 40% to 80% in
increments of 5%. The mist will turn on and off
as necessary to maintain the set humidity level.
To turn off the humidity function, touch the
humidity button one more time after 80%. The
display will show the current humidity level.
5. Touch the UV button (18) to turn on the UV func-
tion. The UV button turns blue when this function
is on. Touch the UV button again to turn it off.
6. To set the humidifier to turn off in 1 to 12 hours.
Touch the time button (19) repeatedly to select:
1H until 12H. To turn off the timer function,
touch he timer button once more after 12H.
Meaning
High level mist
Medium level mist
Low level mist
WWW.VONROC.COM