DeWalt D55270T Manual De Instrucciones página 19

Pulley and Flywheel Alignment
The air compressor flywheel and engine pulley must be in-line (in
the same plane) within 1/16" (1.6 mm) to ensure belt retention within
flywheel belt grooves. To check alignment:
1. Ensure engine ON/OFF switch (C) is in the OFF Position.
. Allow the unit to cool.
3. Disconnect spark plug wire.
4. Drain air tank.
5. Remove outer belt cover.
6. Place a straightedge
(Q) against the outside
of the flywheel (R) and
the engine drive pulley
(S).
7. Measure the distance
between the edge of the
belt (T) and the straightedge at points A1 and A in Figure. The
difference between measurements should be no more than
1/16" (1.6 mm).
8. If the difference is greater than 1/16" (1.6 mm), loosen the
setscrew holding the engine drive pulley to the shaft and adjust
the pulley's position on the shaft until the A1 and A measure-
ments are within 1/16" (1.6 mm) of each other.
9. Tighten the engine drive pulley setscrew. Torque to 145–165 in.-lbs.
(16.4– 18.6 Nm).
10. Visually inspect the engine drive pulley to verify that it is
perpendicular to the drive motor shaft. Points B1 and B of Figure
should appear to be equal. If they are not, loosen the setscrew of
the engine drive pulley and equalize B1 and B, using care not to
disturb the belt alignment performed in Step 8.
A1 A B1
R
T
S
Q
A1 A B1
11. Retighten the engine drive pulley setscrew. Torque to
145– 165 in.-lbs. (16.4–18.6 Nm).
1. Reinstall belt guard.
13. Reconnect spark plug wire.
ACCESSorIES
Recommended accessories for use with your tool are available
for purchase from your local dealer or authorized service center.
If you need assistance in locating any accessory for your tool,
please contact D WALT Industrial Tool Co., 701 East Joppa Road,
e
Baltimore, MD 186, call 1-800-4-D
B
visit our website www.dewalt.com.
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous. Use only accessories rated
equal to or higher than the rating of the air compressor.
SErvICE InForMATIon
B
Please have the following information available for all service calls:
Model Number ____________ Serial Number ___________
Date and Place of Purchase ____________________________
repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be performed by a D
center, a D WALT authorized service center or other qualified
e
service personnel. Always use identical replacement parts.
19
WALT (1-800-433-958) or
e
WALT factory service
e