Publicidad
Idiomas disponibles
Idiomas disponibles
SERVICE AND ADJUSTMENTS
6. ATTACH MOWER SIDE SUSPENSION ARMS (A) TO
CHASSIS (See Fig. 28)
•
Position front hole in side suspension arm (A) over
pin on outside of tractor chassis and secure with large
washer and large retainer spring (B).
•
Repeat on opposite side of tractor.
D
A. MOWER SIDE SUSPENSION ARMS
B. RETAINER SPRING
D. RIGHT SIDE REAR MOWER BRACKET
7. ATTACH REAR LIFT LINKS (C) (See Fig. 29)
•
Insert rod end of rear lift link (C) into hole (U) in tractor
lift shaft suspension arm and pivot link down to mower.
•
Lift rear corner of mower and position slot in link as-
sembly over pin on rear mower bracket (D) and secure
with large washer and large retainer spring.
•
Repeat on opposite side of tractor.
D
C. REAR LIFT LINK(S)
D. RIGHT SIDE REAR MOWER BRACKET
U. HOLE
8 ATTACH FRONT LINK (E) (See Fig.30)
•
Turn steering wheel to position wheels straight forward.
•
From front of tractor, insert rod end of front link (E)
through front hole in tractor front suspension bracket (F).
•
Move to left side of mower and and insert large retainer
spring (G) through hole in front link (E) behind front
suspension bracket (F).
A
Fig. 28
U
C
Fig. 29
•
Insert other end of link (E) into hole in front mower
bracket (H) and secure with washer and small retainer
spring (J).
NOTE: Requires deck lifting.
FRONT LINK
LOCATION
B
E. FRONT LIFT LINK ASSEMBLY
F. FRONT SUSPENSION BRACKET
G. LARGE RETAINER SPRING
H. FRONT MOWER BRACKET
J. SMALL RETAINER SPRING
M. ENGINE CLUTCH PULLEY
9 INSTALL BELT ON ENGINE CLUTCH PULLEY (M)
(See Fig. 19 & 31)
•
Disengage belt tension rod (K) from locking bracket (L).
•
Install belt onto engine clutch pulley (M).
M
M. ENGINE
CLUTCH PULLEY
IMPORTANT: Check belt for proper routing in all mower
pulley grooves and under mandrel covers.
•
Engage belt tension rod (K) on locking bracket (L).
CAUTION: Belt tension rod is spring loaded.
Have a tight grip on rod and engage slowly.
•
Raise attachment lift lever to highest position.
•
If necessary, adjust gauge wheels before op er at ing
mower as shown in the Operation section of this manual.
21
M
F
G
E
Fig. 30
Fig. 31
H
J
Publicidad
