Kettler CYCLE M Instrucciones De Montaje página 5

• The exercise cycle has a magnetic brake system. The braking
system is adjustable
• The equipment is dependent of revolutions per minute.
• Please ensure that liquids or perspiration never enter the machine
or the electronics.
!
Ensure that your working area is free of possible sources
of danger, for example don't leave any tools lying around.
Always dispose packaging material in such a way that it may
not cause any danger. There is always a risk of suffocation if
children play with plastic bags!
• Ensure that you have received all the parts required (see check
list) and that they are undamaged. Should you have any cause
for complaint, please contact your KETTLER dealer.
• Before assembling the equipment, study the drawings carefully
and carry out the operations in the order shown by the diagrams.
The correct sequence is given in capital letters.
• The equipment must be assembled with due care by an adult
person. If in doubt call upon the help of a second person, if pos-
sible technically talented.
• Please note that there is always a danger of injury when working
with tools or doing manual work. Therefore please be careful
when assembling this machine.
When ordering spare parts, always state the full article number,
spare-partnumber, the quantity required and the S/N of the product
(see handling).
Example order: Art. no. 07627-920 / spare-part no. 68009024
/ 1 pieces / S/N .................... Please keep original packaging
of this article, so that it may be used for transport at a later date,
if necessary.
Goods may only be returned after prior arrangement and in
(internal) packaging, which is safe for transportation, in the original
box if possible. It is important to provide a detailed defect description
/ damage report!
Important: spare part prices do not include fastening material; if
fastening material (bolts, nuts, washers etc.) is required, this should
be clearly stated on the order by adding the words „with fastening
material".
• Before use, always check all screws and plug-in connections as
well as respective safety devices fit correctly.
• Always wear suitable shoes when using.
• Nobody may be in the moving range of a training person during
training
• The fastening material required for each assembly step is shown
in the diagram inset. Use the fastening material exactly as
instructed.
• Bolt all the parts together loosely at first, and check that they have
been assembled correctly. Tighten the locknuts by hand until resis-
tance is felt, then use spanner to finally tighten nuts completely
against resistance (locking device). Then check that all screw con-
nections have been tightened firmly. Attention: once locknuts have
been unscrewed they no longer function correctly (the locking
device is destroyed), and must be replaced.
• For technical reasons, we reserve the right to carry out preliminary
assembly work (e.g. addition of tubing plugs).
Waste Disposal
KETTLER products are recyclable. At the end of its useful life please
dispose of this article correctly and safely (local refuse sites).
GB
USA
5