Descargar Imprimir esta página

Danby DAR044A6MBDB Manual Del Propietário página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the three screws from the back of the
worktop. Lift the back of the worktop and pull it
toward the front of the appliance to remove it.
Remove the worktop hinge hole cover from the
left side of the worktop and move it to the hinge
hole on the right side of the worktop.
2. Remove the door spindle cover that covers the
hinge on the top left side of the door. Remove
the hole cover from the top right side of the
door. Removing the hole cover may require a
fl at blade screwdriver.
3. Remove the upper hinge from the top right
side of the cabinet. Remove the door from the
cabinet.
4. Remove the lower hinge hole cover from the
bottom left side of the door and move it to the
bottom right side of the door.
5. Remove the adjustable foot and the lower
hinge from the bottom right side of the cabinet.
Remove the solid foot and screws from the
bottom left side of the cabinet. Install the solid
foot on the bottom right side of the cabinet.
Install the lower hinge and the adjustable foot on
the lower left side of the cabinet.
6. Remove the hinge pin from the upper hinge. Flip
the upper hinge over and install the hinge pin on
the other side.
7. Install the upper hinge and door onto the
cabinet.
8. Install the door spindle cover to cover the hinge
on the top right side of the door. Install the hole
cover in the hole on the top left side of the door.
9. Install the worktop by laying it on top of the
appliance and pushing it toward the back until
it clicks into place and then reinstall the three
screws at the back.
Note: When reinstalling the door, ensure that the
top of the door is level with the top of the cabinet
and that the rubber gasket makes a good seal with
the cabinet all the way around.
1
2
3
4
5
6
7
8
5

Publicidad

loading