Charging Base - SOLAC LUCID i10 Instrucciones De Uso

before plugging in the charger.
- Connect the appliance to a socket that can
supply a minimum of 10 amperes.
- The charger's plug must fit correctly into the
mains socket. Do not alter the plug. Do not use
plug adaptors.
- Do not force the power cord. Never use the
power cord to lift up, carry or unplug the battery
charger.
- Do not touch the plug with wet hands.
- Do not use the appliance if the cable or plug is
damaged.
- If any of the appliance casings breaks, im-
mediately disconnect the appliance from the
mains to prevent the possibility of an electric
shock.
- Do not use the appliance if it has fallen on the
floor, if there are visible signs of damage or if it
has a leak.
- Avoid all contact with the liquid that could be
released from the battery. In case of contact
with eyes, wash them thoroughly and seek me-
dical advice. The liquid spilled from the battery
may cause irritation or burns.
USE AND CARE:
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance to gather up water or
any other liquid.
- Do not use the appliance if the on/off switch
does not work.
- Respect the MAX level indicator.
- Remove the batteries from the appliance if you
are not going to use it for some time.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Do not work on areas where there are metal
objects, such as nails and/or screws.
- Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
- Do not open the battery/ies under any circum-
stances whatsoever.
- When the battery/ies is not in use, keep it away
from other metal objects like paper clips, coins,
keys, screws ... that could connect a terminal
to another.
- Do not shortcircuit the battery terminals as this
may cause an explosion or fire.
- The battery/ies should be stored at a tempera-
ture of below 40ºC.
- Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
- Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.
SERVICE:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
- CAUTION: There is a risk of fire if the
appliance's cleaning is not done according to
these instructions.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
DESCRIPTION
TOP VIEW
A Robot vacuum cleaner top cover
B Antiscratch band
C Front impact infrared sensor
D Operation button
E Red light fixed or blinking error
F Operating light
G Charge light indicator.
H Selfcleaning brush
BOTTOM VIEW
I Antifall sensors
J Side brushes
K Load contact points
L Swivel wheels
M Right wheel
N Left wheel
O Main rotative brush
R Power interuptor
S Battery cover

CHARGING BASE

U Charging base