Battery Charge - SOLAC LUCID i10 Instrucciones De Uso

BATTERY CHARGE:

- Warning: A new battery does not come with a
full charge and must be fully charged before
using the device for the first time.
- Charge the battery at room temperature bet-
ween 4 and 40ºC.
- Turn on the ON / OFF button located on the
bottom of the robot.
- Put the robot in the charging base and ensure
that the automatic charging poles are aligned
correctly.
- Operation button (D): the red LED will light
blinking. When the LED stops blinking the robot
is loaded. Load the robot for 4 hours before the
first use.
ACTIVATE THE ROBOT
- Before starting use, ensure that the power
switch (R) is on.
- Press the operation button (D) to awaken the
robot.
- Press the operation button (D) to start cleaning
in AUTO (AI) mode, you can also start cleaning
by pressing the AUTO button on the remote
control.
- NOTE: If the battery is about to run out, the
robot will return to the charging base automati-
cally to recharge.
- NOTE: If the load base is inaccessible, the
robot can not be recharged, it will return to the
initial situation and the cleaning system will
end. In this case, place the robot manually in
the charging base so that it can be recharged
correctly.
PAUSE THE ROBOT
- To stop the robot press the operation button (D)
or press the on / off button (AL) on the remote
control.
- To resume the cleaning cycle, press the opera-
tion button (D) again.
- For the robot to return to the charging base (U)
press the Go Home button (AJ).
POWER OFF THE ROBOT
- To turn off the robot press the operation button
(D) next until the operation indicator goes off.