10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the
wall control but do not wish to use the handheld remote
control, please proceed to Section 11.
Gently pull on remote control cover to separate top
and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each wire
as close to the wall control as possible. [Refer to
diagram 2.]
Install one 12-volt battery (included) in wall control.
[Refer to diagram 2.]
WARNING: Battery is not rechargeable.
Non-rechargeable batteries are not to be recharged.
Batteries are to be inserted with the correct polarity.
The dimmer switch (labeled ON and D) has been
pre-set to the "ON" position (ON). If you do not wish to
have dimming capability, please move the switch to
the "OFF" position (D). [Refer to diagram 2.]
Align holes in wall control with posts located on inside
of TOP part of remote control cover and press together
firmly. Place wall control into BOTTOM part of remote
control cover, aligning posts in top of remote control
cover with post holes in the bottom.
[Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and bottom
of remote control cover together until you hear a click
at each end, indicating that the remote control cover
has closed completely.
IMPORTANT: Store the handheld remote control away
from excess heat or humidity. To prevent damage to
handheld remote control, remove the battery if
remote control will not be used for long periods.
NOTE: Remove batteries with low or no charge and
dispose of properly.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK. " - When disposing
of household alkaline batteries, it is best to check with
your local and state recycling or household hazardous
waste coordinators concerning the specifics of the
program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or 1-877-2-RECYCLE
or visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
battery away from children.
diagram 1
dimmer
switch
diagram 2
post hole
remote control
cover, BOTTOM
diagram 3
page 10
remote control
cover
(top)
(bottom)
wall control
wire
III
IV
II
V
VI
I
wire
wire
12V battery
hole
IV
III
II
V
VI
I
wall
remote control
control
cover, TOP
post