Craftmade Ricasso RIC60 Guia De Instalacion página 8

7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
8. Blade Assembly.
BLADE OPTIONS: This fan can be used with
TWO or FOUR blades. If TWO-blade option is
chosen, install blade arm walls opposite each
other using blade arm screws and lock washers
referred to in third paragraph below.
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and
break.
Locate blade attachment screws/washers in
hardware pack. Hold blade arm up to blade and
align holes. Place blade plate on top of blade,
aligning posts in blade plate with holes in blade
as shown and insert 3 blade attachment
screws/washers, with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. Align blade arm holes
with motor screw holes and attach blade arm
with lock washers and blade arm screws. Before
securing screws permanently, repeat procedure
with remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
canopy
screw
blade
arm
wall
lock washers
page 8
hanging
bracket
screw
canopy cover
blade attachment
screws/washers
blade plate
blade
blade arm
blade arm screws