Publicidad
Idiomas disponibles
Idiomas disponibles
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing
female plug from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was
previously removed and securely tighten all 3
screws with a Phillips screwdriver. [Refer to
diagram 1.]
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
If you wish to use the light kit, connect female
plug from motor housing to male plug from the
LED light kit, matching up the colors on the
male plug with the colors on the female plug
for correct fit. Make sure that plugs connect
securely. [NOTE: If you will NOT be using the
light kit, do NOT connect the plugs.] Carefully
arrange wiring within the back of LED light
kit. Align slotted holes in light kit fitter with
loosened screws in fitter plate. Twist light kit
fitter to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely. [Refer to diagram 2.]
Locate slots on shade and align with nodules
on inside of LED light kit.
shade and turn
to the RIGHT (clockwise)
slides completely into place.
3.]
If you do NOT wish to use the light,
on metal cover and align with nodules on
inside of
LED light
kit. Gently push up on metal
cover and turn to the
RIGHT (clockwise)
slides completely into place.
diagram 4.]
CAUTION:
Do not connect the LED light kit if
you do NOT wish to use the light.
WARNING: Metal cover will be HOT if light is
left on.
Gently push up on
until it
[Refer to diagram
locate slots
until it
[Refer to
motor plate
female plug
diagram 1
diagram 2
nodules
slots
diagram 3
nodules
slots
diagram 4
page 9
motor
housing
fitter plate
motor
housing
female
plug
male
plug
LED light kit
LED light kit
shade
LED light kit
metal cover
Publicidad
