Craftmade Ricasso RIC60 Guia De Instalacion página 7

6. Wiring.
WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to
the OFF position.
CAUTION: Be sure outlet box is properly grounded and
that a ground (GREEN or Bare) wire is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the instructions, please use a qualified
electrician.
Note: Excess lead wire length from the fan can be cut
to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from
fan to BARE/GREEN wire from ceiling with wire
connector provided.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
[PLEASE NOTE: Wall and/or handheld remote control
must be used for fan to operate. If you do not wish to
use the wall control, please proceed to Section 7 below
to continue with fan installation.]
To install wall control, remove existing wall switch.
Wire one of the wall controls with wire connectors
provided as shown in diagram at right.
*Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires
and taped wire connectors into outlet box.
Install one 12-volt battery (included) in wall control.
IMPORTANT: Wall control will not function unless
battery is installed.
WARNING: Battery is to be inserted with the correct
polarity.
Since this fan comes an LED light kit, the dimmer
switch (labeled ON and D) has been pre-set to the
"ON" position (ON). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (D).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach plate
(included) to wall control using 2 screws provided
with the wall control.
white supply wire
black supply wire
from ceiling
black
white
white
black
from fan
outlet box
green/ green/
green/
bare bare bare
ground ground
ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
page 7
ground
(green or bare)
wire
connector
ground
or bare)
*
wall
control
IV
III
II V V
I VI
green
black (OUT to fan)
black
(TO POWER supply)
12V battery
(green
dimmer
switch
plate