Ariston 3319483 Instrucciones De Instalacion Y Uso página 32

INSTALLATION (wireless version)
ONLY FOR THE FOLLOWING MODELS:
3319484 – 3319487 – 3319490
In order to function properly, the wireless timer-
controlled thermostat must be combined with
a receiver. The timer-controlled thermostat
- receiver combination is preconfigured by
the manufacturer; this means that the devices
must be operated in the same location.
RECEPTION TEST
In order to verify the correct signal
transmission, power the timer-controlled
thermostat by inserting the batteries supplied
with the kit, as mentioned previously. Keep
the timer-controlled thermostat roughly 2–3
metres away from the receiver and perform the
procedure outlined in the receiver instruction
manual.
After completing the test, proceed with the
timer-controlled thermostat installation.
Wall mounting
- Fasten the base of the timer-controlled
thermostat to the wall in the chosen
position, using the screws supplied with
the kit (Fig. 1)
- Position the timer-controlled thermostat onto
the base and push it downwards (Fig. 2)
Mounting the table-top support
- Fasten the support to the base (Figs. 3 and 4)
- Position the timer-controlled thermostat onto
the base and push it gently downwards (Fig. 5)
NOTE:
If the green LED on the receiver does not flash
or if the red LED does not turn on, one of the
components of the system (timer-controlled
thermostat and receiver) has been swapped
or replaced.
To solve the problem, consult the receiver
instructions for the reconnection procedure.
32 / GB
1
2
3
5
4