Internet Connection; Remote Control - Sony HT-Z9F Manual De Instrucciones

and wireless LAN router closer to
each other.
 Devices that use a 2.4 GHz frequency
band, such as a microwave,
BLUETOOTH, or digital cordless
device, may interrupt
communication. Move the main unit
away from such devices, or turn off
such devices.
 The wireless LAN connection may
become unstable depending on the
usage environment, especially while
using the BLUETOOTH function of the
system. In this case, adjust the usage
environment.
The wireless LAN router you want is
not shown in the wireless network
list.
 Press BACK to return to the previous
screen, and try [Wi-Fi Setup] again
(page 26). If the wireless LAN router
you want is still not detected, select
[New connection registration] from
the network list, then select [Manual
registration] to input a network name
(SSID) manually.

Internet Connection

You cannot connect the system to
the Internet.
 Check the wired or wireless LAN
connection.
 Restart the router or wireless LAN
router.
Wireless Multi Room
The sound is delayed behind the
picture.
 When the sound of the [TV] (including
the connection with the BLUETOOTH
function), [HDMI1], [HDMI2],
[Bluetooth Audio] input is played in
the wireless multi room function, the
sound of the system is delayed
behind the picture to synchronize
with the sound of other speakers. If
you are bothered by the time gap
between the sound and picture, try
the following.
• For the HDMI1 or HDMI2 input: Press
OPTIONS and set [Multi-room Sync]
to [Off].
• For the TV or analog input: Press
OPTIONS, / until "MSYNC"
appears on the front panel display,
(enter), then press / until
and
"OFF" appears on the front panel
display and press
The sound of the system is
synchronized with the picture though
the sound output from other
speakers is delayed.
The wireless multi room function
cannot be used on Sony | Music
Center.
 Connect the mobile device to the
same network as that of the system.

Remote Control

The remote control of this system
does not function.
 Point the remote control at the
remote control sensor on the main
unit (page 10).
 Remove any obstacles in the path
between the remote control and the
system.
 Replace both batteries in the remote
control with new ones, if they are
weak.
 Make sure you are pressing the
correct button on the remote control.
TV remote control does not work.
 This problem might be solved by
enabling the IR repeater function
(page 33).
(enter).
73
US