Chacon 34151 Manual De Uso página 6

Test mode
Fault mode
Alarm mode
End of product life
3. Advice - installation locations
We recommend that you install the gas leak detector near your cooker, water heater and near
all gas sources. Methane (or town gas), biogas or natural gas is lighter than air and therefore
rises, so place your device of about 30 cm from the ceiling.
To avoid damage to the product and to prevent false alarms, do not install the unit in the
following locations:
• Air inlet/outlet areas, exhaust fans, doors/windows with strong air circulation.
• Areas with moisture and water drops, e.g. in your bathroom.
• Areas directly above a source of heat or steam.
Note: If the room must be painted or renovated, please install the detector after the renova-
tion or painting work.
4. Troubleshooting
Note: For any faults that cannot be resolved by yourself, do not dismantle the detector,
please contact the distributor for advice.
Faulty
The green light of the power
source is not on
Red LED flashing
Continuous yellow LED
Flashing red led
/
Possible reason(s)
Power source cable not connec-
ted properly
Power source indicator damaged
or circuit failure
/
/
/
Flash
Action(s) to be taken
Check and connect the cable to
the power source correctly
Contact the distributor for repair
Beeps 4x
Continuous beep
Beeps 4x repeating
Beeps 3x repeatedly