Publicidad
Idiomas disponibles
Idiomas disponibles
5 ASSEMBLY
–
Mount screws
Guideline
Screw, handlebar clamp
The tightening torque must not be exceeded.
Tightening the clamp screws does not change the preload in the elastomers.
Incorrect mounting may limit the operation.
The length of the elastomers must be checked every
30 operating hours. If the length of the elastomers
is less than the specified value, the elastomers must
be replaced.
After each fall, the steering damper system must be checked for any damage and replaced if necessary.
12
8
and tighten evenly.
Info
Due to their physical properties, polyurethane elastomers have a creep factor. We recommend against
securing the motorcycle by the handlebars during transport.
M8x45
≤ 13.4 mm (≤ 0.528 in)
16 Nm (11.8 lbf ft)
Publicidad
