Gaggenau 200 Serie Instrucciones De Uso Y Montaje página 8

Causes of Damage
NOTICES:
▯
Risk of damage due to corrosion. Always turn
appliance on when cooking to avoid
condensation buildup. Condensation can lead to
corrosion damages.
▯
Risk of damage due to ingress of humidity into
the electronic circuitry. Never clean operator
controls with a wet cloth.
▯
Surface damage due to incorrect cleaning.
Clean stainless steel surfaces in the grind
direction only. Do not use any stainless steel
cleaners for operator controls.
▯
Surface damage due to strong or abrasive
cleaning agents. Never use strong and abrasive
cleaning agents.
▯
Risk of damage from condensation back flow.
Install exhaust vent at a slight downward slope
away from the appliance (1° slope).
Protecting the environment
Unpack the appliance and dispose of the packaging
in an environmentally friendly manner.
8
Operating modes
You can use this appliance in the air extraction or the
recirculation mode.
Exhaust air mode
The air that is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct
used for ventilating furnace installation areas.
▯
If the ventilation is intended to pass through a
smoke or exhaust chimney that is not in
operation, the responsible area heating
inspector must give approval.
▯
If the ventilation passes through an external wall,
use a telescope wall sleeve.
Recirculation
The aspirated air is cleaned by the
grease filters and an activated charcoal
filter and is returned to the kitchen.
Note: You must install an activated charcoal filter to
bind odors in the recirculation mode. Refer to the
manual or ask your specialist dealer for details of the
various options for operating the appliance in the
recirculation mode. You can obtain the necessary
accessories from specialist dealers, from our after-
sales service or in the online shop.
When used in recirculation mode, to reduce the Risk
of Fire and Shock use only conversion kit Model
AA200110 / AA200816. Please refer to the section
"Accessories" in this manual.