Uline H-10160 Manual De Instalación página 2

2. Drill holes 2⁄" deep using 3/8" drill bit. Insert plastic
anchors (B2) into the pre-drilled holes. (See Figure 3)
NOTE: It is recommended to use a masonry drill
bit for concrete walls.
Figure 3
3. Keep magnetic level attached to wall plate. Using
a drill and 13 mm socket, install wall plate onto wall
using lag screws (B1) and washers (B3). (See Figure 4)
Figure 4
Level
ATTACHING TO DRYWALL
STOP! If mounting to drywall, brackets must be
properly attached to wood studs behind the
wall.
1. Using stud finder, locate studs that will be used
for mounting. Studs are commonly spaced 16"
center-to-center. At roughly the desired location
and height, mark where studs are located.
PAGE 2 OF 12
INSTALLATION CONTINUED
2⁄"
3/8"
2. Align wall plate with studs and move to desired
location. Place level on top of the wall plate to
ensure it is leveled correctly. Mark where holes for
screws are to be located. (See Figure 5)
Figure 5
Level
3. Drill holes 2" deep using 3/16" drill bit. (See Figure 6)
Figure 6
4. Keep magnetic level attached to wall plate. Using
a drill and 13 mm socket, install wall plate onto wall
using lag screws (B1) and washers (B3). (See Figure 7)
Figure 7
Level
Wood Stud
2"
3/16"
0922 IH-10160