Uline H-10160 Manual De Instalación página 3

ATTACHING BRACKETS TO MONITOR
Determine screw size that is compatible with the monitor.
Using the square washers (A6) and spacers (A5), install
each bracket to the monitor.
SQUARE WASHER
Small hole for M4 screws (A1)
Medium hole for M5 and M6 screws (A2, A3)
Large hole for M8 screws (A4)
NOTE: For monitors with flat backs, use
spacers (A5) on the outside of brackets.
(See Figure 8)
Figure 8
Bracket
NOTE: For monitors with a curved back or
obstructions, place spacers (A5) on the side
closest to the monitor. (See Figure 9)
Figure 9
PAGE 3 OF 12
INSTALLATION CONTINUED
Spacer
Square
Washer
Bracket
Spacer
Square
Washer
MOUNTING MONITOR TO WALL PLATE
With second person, carefully lift and align brackets on
the monitor with the wall plate. The brackets will clip into
the wall plate and lock into position. (See Figures 10-11)
NOTE: Strings that are used to release the
monitor from the mount may be visible after
installation. These can be hidden behind the
monitor using the magnetic tips.
Figure 10
Wall
Wall Plate
Figure 11
Wall
Clip bracket
onto wall plate.
Bracket
Hide strings using
magnetic tips.
0922 IH-10160