Publicidad
Idiomas disponibles
Idiomas disponibles
Tooth spacing
Cutting capacity
Machine Weight (Bare
Tool)
** X may be followed by one or two characters. All
models are the same except model number and
trademark. The suffix in models may be number from
"1" to "999" or English letter "A" to "Z" or "M1" to"
M9" which means different package or the various of
accessories packed in the package.
*** Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
SUGGESTED BATTERIES AND
CHARGERS
Category
20V Battery
10
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose
the type according to the work you intend to
undertake. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
4. OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
Warning! Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
Cordless Hedge Trimmer
1''(25mm)
3/4''(19mm)
7.5 lbs (3.4 kg)
Type
Capacity
WA3575
2.0 Ah
WA3525
2.0 Ah
WA3742
0.4 A
WA3884
4.0 A
WA3770
2.0 A
WA3881
2.0 A
WA3875
2.0 A
ACTION
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
Assembling the front handle
NOTE : The handle is designed to
prevent being assembled in wrong
direction . If you find it cannot be
installed, please turn it around.
Charging the battery pack
NOTE :
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More details
can be found in charger's manual.
Installing and Removing the battery
pack
NOTE :
• This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the
two batteries at the same time.
• When you use two batteries with
different power, the machine
will only run to the lower
common denominator.
OPERATION
Remove the blade sheath
Starting and stopping
Rotating rear handle
NOTE :
• Unlock the locking switch before
rotating.
• After rotating the handle to the
desired position, adjust it a little until
a click can be heard.
WARNING:
• Always make sure that the handle
is locked in the desired position
before operation.
• Always make sure the locking
switch is locked before starting
the hedge trimmer.
• Do not rotate the handle when the
trimmer is being operated.
FIGURE
See Fig. A
See Fig. B1,
B2
See Fig. C
See Fig. D
See Fig. E
See Fig.
F1, F2
See Fig. G1,
G2
EN
Publicidad
