Publicidad
3. Connect the output tray on the right side of the machine
page
42).
4. Turn the cut depth knob to the smallest circle next to the bar for a Standard
Cut (Figure 4-4). It is recommended that the user select this setting first to
cut the envelopes to reduce the chance of cutting the contents.
• If you find incomplete cutting, use the second cut setting.
• The third depth is for envelopes with glued edges, or to be used if the
second is not opening the envelope.
• The No Cut position is normally used when only counting the mail.
Note: More accurate counting is achieved with smaller stacks of mail.
38
Omation® Series 210™ Envelopener® Operator Manual
No Cut
Figure 4-4: Cutter depth knob
OPEX Corporation
(Figure 4-9 on
Third Cut (deepest)
Second Cut (deeper)
Standard Cut
(shallowest)
Operation
Publicidad
