Publicidad
Idiomas disponibles
Idiomas disponibles
NEW CONSTRUCTION INSTALLATION INSTRUCTIONS (continued)
4. Remove the wiring cover from the fan housing (A). Pull the
house wires through the wiring cover hole. Using the attached
quick connectors, secure 120V house wiring from the wall
switch to the fan as shown in the wiring diagram on page 5.
14 AWG is the smallest conductor that should be used for
branch circuit wiring.
Carefully push the connected wires back into the wiring box
housing. Reattach the wiring box cover.
CAUTION: If the house electrical wires do not match the
colors from the fan wiring diagram on page 5, you must
determine what each house wire represents before
connecting. You may need to consult an electrical
contractor to determine safety.
5. Connect a 6 in. circular duct (not supplied) and vent to the
outside. Secure it with duct tape (not supplied) or a clamp
(not supplied) to make the connection secure and airtight.
Turn on the power source. Check the fan for any abnormal
sounds or vibrations.
6. Attach the grille (B) by pinching the mounting springs and
inserting into the narrow rectangular slots in the fan
housing (A).
EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK! Ensure the
electricity to the wires you are working on is shut off.
Either remove the fuse or turn off the circuit breaker
before removing the existing bath fan or installing the
new one.
HomewerksWW.com
4
House
Wires
Wiring
Cover
5
6
Mounting
springs
7
Quick Connector
Product Wires
A
A
B
Publicidad
