Original Prusa MINI+ Manual De Instrucciones página 36

PASO 15 Uniendo las piezas - fase 1
Move the XZ-axis closer to the Y-axis so that the Y-axis motor cable reaches the
electronics.
Guide the Y-axis motor cable through the hole in the electronics box. Do not
connect the cable to the electronics yet, we'll connect it later.
Push both parts together and try fitting the "clamp" (XZ assembly) directly on the
M3nE nut, which you have moved to the centre of the extrusion.
WARNING: Be careful not to pinch the Y-axis motor cable between both parts!
Use the M3x40 screw to connect both parts. In case you can't reach the thread of
the nut, wiggle with the screw a bit inside the plastic base of the printer. DON'T
tighten the screw fully yet!
PASO 16 Uniendo las piezas - fase 2
Take the second M3nE nut from the left and move it all the way to the right, use the
Allen key and gently push it in. There is a notch inside, which will align it properly
for the second screw.
Use the M3x20 screw and again tighten it just slightly, but ensure you have
reached the nut. DON'T tighten the screw fully yet!
36
Montando tu MINI+ (soporte bobina impreso)
Original Prusa MINI+ semi-montada