Original Prusa MINI+ Manual De Instrucciones página 40

PASO 23 Connecting the LCD
Carefully remove the free end of the LCD cable from the box with the electronics
and guide the cable between the Y-axis motor cable and the extrusion.
Connect the cable to the board on the LCD. Mind the correct orientation of the
connector. Use the notch as a guide
Insert the connector in the socket on the board. Make sure it is all the way in.
PASO 24 Guiding the LCD cable
PASO 25 Connecting the Y-axis motor
Gently pull the Y-axis motor cable into the electronics. Do not stretch the cable. Do
not use excessive pulling force. You can damage the cable.
Connect the Y-axis motor cable into the empty slot in the top row on the Buddy
board. Create a loop with the rest of the cable like in the picture.
40
Montando tu MINI+ (soporte bobina impreso)
Original Prusa MINI+ semi-montada
Gently insert the cable inside the
extrusion. Leave some slack outside
near the LCD, so you can tilt it later
on.
Pro tip: to insert the cable in the
extrusion carefully bend it into two
halves along its length.