Original Prusa MINI+ Manual De Instrucciones página 48

PASO 40 Conectando la fuente de alimentación
Remove the protective film from the display.
Connect the MINI power supply to the printer. Keep in mind the connector isn't
symmetrical.
Place the PEI MINI sheet on the heatbed. Double-check it is oriented correctly.
...and you're done! Good job!
Prusa veterans: SuperPINDA sensor height is set from the factory, no need to adjust
it now. Optimal height is 0.8-1.0 mm between the nozzle's tip and the sensor.
In case you have any hardware issues, after the assembly, please visit our online
guide Resolviendo problemas de montaje de la MINI/MINI+
PASO 41 What is next?
Now, please read the 3D Printing Handbook, which is tailor-made for your printer.
The latest version is always available at
WARNING: Always check for the latest firmware. You can do it online at
prusa3d.com/drivers
instructions are in the Handbook. (If the USB drive includes a newer firmware
than already installed, you will be prompted during the boot of the printer.)
Calibrate the printer according to the Handbook and use the bundled test prints
to ensure your printer works correctly.
If you encounter any problems at all, don't forget you can always check out our
knowledge base at
Don't forget to join the biggest Prusa community! Download the latest models in
STL or G-code tailored for your printer. Register at
48
Montando tu MINI+ (soporte bobina impreso)
or insert the bundled USB drive in the printer. Detailed
help.prusa3d.com
Original Prusa MINI+ semi-montada
prusa3d.com/3dhandbookMINI
Printables.com
at help.prusa3d.com.