Original Prusa MINI+ Manual De Instrucciones página 41

PASO 26 Connecting the heatbed cable
Take the cable bundle from the heatbed and guide it into the box from the top,
there is no dedicated hole. Connect the individual cables to the board:
Thermistor (H)
Heatbed heater
Gently push the cables inside the box and position the wrap near the top left corner,
where most of the cables enter the box.
PASO 27 Filament sensor (optional)
Montando tu MINI+ (soporte bobina impreso)
Original Prusa MINI+ semi-montada
Some of the following steps are
marked as optional. If you have a
printer without the filament sensor,
please skip to the step
electronics
For the following steps, please
prepare:
Filament sensor (1x)
Covering the
41