Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Always wear eye protection
when operating or
performing maintenance
on this tool.
CLUTCH ADJUSTMENT
Disconnect the air supply from the Tool before
proceeding.
1.
Rotate the Clutch Adjusting Hole Cover far enough to
expose the clutch adjusting hole in the Clutch Housing.
2.
Insert a 1/4" hex wrench into the Bit Holder and rotate
the clutch mechanism until the area having an opening
between the faces of the Clutch Adjusting Nut Washer
and Clutch Adjusting Nut is visible.
WARNING SYMBOL IDENTIFICATION
Read this manual before
operating tool.
ADJUSTMENTS
WARNING
3.
Using a screwdriver that has a #1 Phillips tip, insert the
tip of the screwdriver into the opening and rotate the
screwdriver to adjust the Clutch. Rotate the
screwdriver clockwise to decrease Clutch Spring
tension and torque and counterclockwise to increase
the tension and torque.
The most satisfactory adjustment is usually
obtained by using the tool on the actual application
and increasing or decreasing the delivered torque
until the desired setting is reached. In any event, it
is recommended that final adjustment be made by
gradual progression.
2
WARNING
Always wear hearing
protection when operating
this tool.
Publicidad
