Publicidad
Idiomas disponibles
Idiomas disponibles
MAIN BURNER CLEANING PROCEDURE
Turn off the gas supply.
Remove the manifold (See "Replacing Main Burners").
Look inside each burner with a flashlight.
Clean the inside of the burners with a wire (a straightened-out coat hanger will work).
Check and clean the air shutter opening at the ends of the burners. Check and clean
the valve orifices at the base of the valves. Use a Steel bristle brush to clean outside of
burners. This is to make sure all the burner ports are fully open.
CAUTION: Do not enlarge the burner ports when cleaning.
REPLACING MAIN BURNERS
1)
Your Weber
®
gas barbecue must be OFF and cool.
2)
Turn gas OFF at source.
3)
To remove control panel:
(a)
Take off the burner control knobs.
(b)
Remove screw and washer from back of control panel with a Phillips screwdriver.
(c)
Tilt the back edge of the control panel up. Push in on the front edge to release
locking tabs.
(d)
Disconnect the igniter wires from the ignition module.
(e)
Carefully pull control panel away from frame.
WWW.WEBER.COM
®
MAINTENANCE
c
d
15
a
b
e
15
Publicidad
