HSM SECURIO P44i Manual De Instrucciones página 19

Message
displayed
Door open
Safety element
active
Metal detection
Motor overloaded
Light barrier dusty
Oil reservoir empty Oil reservoir
02/2017
Fault cause Remedy
Door open • Close the door.
Safety ele- • Snap the safety element into place.
ment not Note
engaged The movement of the safety element is monitored during the shred-
ding process.
Metal in the • Press the "R" button and pull the paper out of the feed slot.
paper • Remove any metal which is in the paper or on the safety element.
• Acknowledge the fault.
The motor has • Allow the shredder to cool down for 30 min. before using it again.
overheated.
Photoelectric • Clean the photoelectric sensor in the paper feed using a dry brush
beam ob- or cloth.
scured by
paper dust
• Fill the reservoir with cutting apparatus oil.
empty
1
2
HSM SECURIO P44i
Only use HSM special oil.
Reservoir volume: 250 ml
Press the safety element and lift up the fl ap. The
oil fi lling opening is to the right of the feed chute.
You can fi ll the oil either through the small open-
ing 1 (take out the yellow plug) or the normal
opening 2 (unscrew the red cap).
english
19