Domo DO908DV/A++ Manual De Instrucciones página 30

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
DO908DV/A++
Levelling
The freezer needs to be placed completely upright and level, so that it will not rock.
Check if the 2 adjustable legs are firmly on the ground when the freezer is completely
upright and level.
If not, adjust the legs by screwing or them in or out the freezer.
Caution: This appliance is heave. Be careful.
Reversing the door
The freezer is built with the door hinges on the right side. If you want to switch the
direction in which the door opens, follow the following instructions:
1. Remove the cover of the upper hinge (6).
2. Remove the 3 screws (1) that attach the upper hinge (5) to the freezer. Remove
the upper hinge.
3. Lift the door and place it on a soft surface so that it does not get damaged.
4. Remove the 3 screws (8) that attach the lower hinge (2) to the freezer. Remove
the lower hinge.
5. Remove the left front leg (4) and move it to the right side of the freezer.
6. Replace the cover plate (7) to the right side.
7. Before placing the lower hinge (2), remove the bolt (the right leg) (9) en reverse
the direction of the lower hinge. Install the lower hinge at the bottom left of the
freezer with the 3 screws (8).
8. Screw the bolt (9) back into the lower hinge (2).
9. Place the door in its place, on the lower hinge (2).
10. Close the door and hold it in position while you attach the upper hinge (5) to the
upper left corner of the freezer with the 2 screws (1). Make sure that the door is
straight before fastening the screws.
11. Place the cover (6) onto the upper hinge.
USE
Remove all packaging materials and any promotional stickers before use.
Clean the inside of the appliance with lukewarm water and some bicarbonate or soda
(5ml for 0,5l water). Do not use any soap or detergent, as the smell may linger. Dry
thoroughly.
30

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Do908dv

Tabla de contenido