Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
„ Charging RYOBI 18V Li-ion battery packs
„ Charging USB-C-3.0A and USB-A-2.1A capable devices.
NOTICE:
If charge does not appear to initiate or appears to stop
charging the battery pack before reaching full charge,
check that charger is properly plugged into a power
supply (outlet) and that the power supply is energized. If
so, try charging a different battery pack. If the different
battery pack charges properly, then return the battery
pack that did not charge properly. If a different battery
pack does not charge, return the charger and the battery
pack(s). Make returns to the nearest authorized service
center for service or replacement.
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
OPERATION
KEY HOLE HANGER
See Figure 1, page 7.
To mount the charger, only use the key hole hanging
feature. Screws should be installed so that the center
distance is 4-1/2 in.
CHARGING
See Figures 2 - 3, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time is dependent upon the type of 18V battery pack.
„ Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
„ Connect the charger to a power supply.
„ Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
the
charger, then insert the battery pack into the charger.
„ Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
„ Latches should snap into place to ensure charger is
correctly connected.
„ Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
„ The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
„ When the battery pack is more than 80% charged and
ready for use, the green LED will begin fading on/off
continuously.
„ After the battery is fully charged, the green LED will remain
on while the charger is in Energy Save Mode.
„ Charger will periodically wake from Energy Save mode to
ensure the battery pack remains in a fully charged state.
4 — English
Publicidad
