Ryobi PCG008 Manual Del Usuario página 5

„ To remove the battery pack from the charger, depress
latches and pull up on the battery pack.
„ When the battery pack is fully charged, remove it from
the charger.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly onto
the charger port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
When a hot battery pack is placed on the charger, the red
LED will begin flashing and the green LED will be off. When
the battery pack cools, the charger will automatically begin
charging.
LED FUNCTION OF CHARGER
RED
MODE
Temperature
Flashing
Delay
Error
Flashing Flashing Error
• Try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED Error status repeats
a second time, try charging a different battery.
• If a different battery charges normally, dispose of the pack that received the Error (see your battery pack manual for
instructions).
• If a different battery also indicates Error, the charger should be replaced.
Charging
Ready
Charged/
Energy Save
Mode
NOTE: Maintenance information begins on page 6 after French
and Spanish language sections. Illustrations start on page 7.
OPERATION
GREEN
BATTERY PACK
LED LED
Hot Battery Pack
OFF
Cold Battery Pack
OFF Flashing Charging
More than
OFF Fading
80% charged
Battery full /
OFF ON Energy Save
mode
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the red LED will begin
flashing and the green LED will be off. When the battery
pack warms, the charger will automatically begin charging.
When battery pack reaches cooled temperature,
charger begins charge mode.
When battery pack reaches warmed temperature,
charger begins charge mode.
Battery pack or charger error.
Battery is being charged.
Rapid-charging phase complete. Battery pack may be
used. Battery will finish charging at a reduced rate until
fully charged.
Battery pack is fully charged and charger is in
Energy Save mode.
5 — English
ACTION