Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACHING THE FRONT HANDLE
See Figure 1, page 11.
„ Push the handle onto the shaft until the handle is securely
seated onto the pole between the coupler and the soap
and water controls.
„ Insert the bolt through the bracket and handle as shown.
„ Adjust the handle up or down, if necessary, to desired
operating position.
„ Tighten the wing bolt to secure. Do not overtighten.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
„ The power scrubber can be used to clean exterior and
interior surfaces.
„ This product is not for commercial use.
ASSEMBLY
INSTALLING THE SOAP BOTTLE
See Figure 2, page 11.
Thread the bottle into the tool. Tighten firmly but do not
overtighten.
INSTALLING THE WATER NOZZLE
See Figure 3, page 11.
The nozzle directs the stream of water or soap at the rotating
brush during the cleaning operation.
„ Align the pins to the holes on top of the head.
„ Press firmly to lock into place.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 4, page 11.
„ Unlock the tab and open the battery cover.
„ Insert the battery pack into the product as shown.
„ Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
„ Close the battery cover and lock the tab.
„ To remove, open the cover and depress the latches on
both sides of the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Do not operate the scrubber with the battery door open.
An open door could expose the battery and battery
compartment to wet conditions which could increase the
risk of electric shock.
SELECTING A BRUSH ACCESSORY
Selecting the correct type of brush accessory is important
in order to obtain the best performance from the power
scrubber. Select the brush accessory based on the
application and on the surface you wish to clean. Selecting
the right brush accessory will help you clean more efficiently
and protect the surface being cleaned. To reduce the risk of
property damage, always test the brush in an inconspicuous
area of a surface before beginning a project.
NOTE: A brush accessory with medium bristles is included
with your power scrubber. Brush accessories with hard and
soft bristles can be purchased where you bought this product.
7 – English
Publicidad
