Ryobi PCL1701 Manual Del Operador página 8

BRUSH ACCESSORY SELECTION GUIDE
Soft Bristle (Blue)
Light Duty Cleaning
Medium Bristle (Green)
General Purpose Cleaning
Hard Bristle (Gray)
Heavy Duty Cleaning
INSTALLING/REMOVING BRUSH
ACCESSORIES
See Figure 5, page 12.
The types of brushes accepted: The 1/4 in. hex shaft and the
triangular collet. These brushes are sold separately.
Installing the 1/4 in. collet brush:
„ Remove the battery pack.
„ Insert the post of the brush directly into the 1/4 in. collet.
„ To remove, pull the brush straight out.
Installing the triangular collet brush:
„ Remove the battery pack.
„ Align the triangular hole in the brush accessory with the
triangular collet on the connector.
„ Push the brush accessory onto the connector.
„ Hold the connector sleeve and rotate the brush accessory
counterclockwise to lock it in place.
NOTE: When locked, the triangular hole and triangular
collet will be misaligned.
„ Hold the connector sleeve and rotate the brush accessory
clockwise to unlock and remove the brush accessory.
NOTE: When unlocked, the triangular hole and triangular
collet will be aligned.
STARTING/STOPPING THE POWER
SCRUBBER
See Figure 6, page 12.
To start the motor:
„ Fully depress the on/off button to start the motor.
NOTE: When the motor is on, the brush accessory will
spin continuously.
To stop the motor:
„ Fully depress the on/off button to stop the motor.
NOTE: When the motor is off, the brush accessory will
stop spinning.
NOTE: The trigger is a lock-on trigger. Once the button
is fully depressed, the switch locks on to continually run
until the button is fully depressed again.
OPERATION
TELESCOPING SHAFT
See Figure 7, page 12.
WARNING:
Do not place hand between pivoting head and telescop-
ing shaft. Placement of your hand or fingers in this area
could result in a pinch point injury.
The shaft can be extended or shortened for ease of use.
„ Remove the battery pack.
„ Loosen the telescoping shaft coupler by turning it
counterclockwise. Slide the shaft to the desired position.
„ Tighten the coupler by turning clockwise. Make sure
the shaft is securely tightened before reinstalling the
battery pack.
ADJUSTABLE FRONT HANDLE
See Figure 7, page 12.
The angle of the front handle can be adjusted for ease of
operation and to help prevent loss of control.
„ Remove the battery pack.
„ Set the power scrubber on a flat surface and turn the wing
bolt counterclockwise to loosen the handle.
„ Adjust the handle as desired.
„ Turn the wing bolt clockwise until the handle is securely
tightened before reinstalling the battery pack.
PIVOTING HEAD
See Figure 8, page 12.
„ Remove the battery pack.
„ Place the power scrubber on a sturdy flat surface.
„ Push pivot button and adjust motor head until it snaps
securely into place at one of the six positions indicated
by the notches.
ADJUSTABLE NOZZLE
Adjust the nozzle up and down to direct the water stream
at the top of the installed brush.
FILL THE SOAP BOTTLE
„ Fill the bottle to the max fill line with the soap.
„ Hold the tool horizontally, lift the bottle, and thread into
the unit.
„ Hand tighten only. Do not overtighten.
NOTE: Do not operate scrubber without the soap bottle
in place.
CONNECTING THE GARDEN HOSE
See Figure 9, page 12.
The water supply must come from a water main. NEVER use
hot water or water from pools, lakes, etc.
8 – English