Preparation; Installing/ Removing The (Optional) Battery Pack; Installing The (Optional) Antenna - Kenwood TK-5220 Manual De Instrucciones

INSTALLING/ REMOVING THE (OPTIONAL) BATTERY
PACK
1 Match the guides of the
battery pack with the grooves
on the upper rear of the
transceiver, then fi rmly press
the battery pack in place.
2 Lock the safety catch to
prevent accidentally releasing
the battery pack.
3 To remove the battery pack,
lift the safety catch, press the
release latch, then pull the
battery pack away from the
transceiver.
Note:
◆ For battery pack charging procedures and useage, refer to the
battery charger Instruction Manual.
◆ Before charging a battery pack that is attached to the
transceiver, ensure that the safety catch is fi rmly closed.

INSTALLING THE (OPTIONAL) ANTENNA

Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
2

PREPARATION

1
2
Optional
antenna
3