Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting Bench Top Tool
1. The table is "layed-out" only for RIDGID
bench top power tools.
2. The "Planning" section of this manual
shows the recommended mounting for
RIDGID tools.
3. The tools can be mounted with "bolt &
nut" hardware or "drywall screw" hard-
ware.
4. The layout marks printed on the table
boards (in most cases) will line up the
larger "bolt & nut" holes and the "dry-
wall screw" holes on your RIDGID tool
if you assembled the stand per our ear-
lier recommendation.
5. If you use "bolt & nut" fasteners, use a
5/16" drill bit (not supplied) and drill the
Power Tool
SS1650 16" Scroll Saw
MS1050 10" Compound
Miter Saw
MS1250 12" Compound
Miter Saw
EB4424 Oscillating Edge/Belt
Sander
TS2400 Jobsite Table Saw
TP1300 13" Thickness Planer
NOTE: If mounting bench top power tools
other than RIDGID brand, be certain that:
a. The bench top power tool must not
weigh more than 300 pounds and is
evenly distributed on the particle
board top.
All manuals and user guides at all-guidesbox.com
6. Place the appropriate bolt through the
7. If you use "drywall" fasteners, line the
Hardware for mounting the tool to the
legstand is not supplied.
However, the following hardware is rec-
ommended.
Bolts & Nuts
1/4-20 x 2" Bolt
1/4-20 Nut
1/4 Lockwasher
1/4 Flat Washer
1/4-20 x 2-1/2 Bolt
1/4-20 Nut
1/4 Lockwasher
1/4 Flat Washer
1/4-20 x 3-1/2" Bolt
1/4-20 Nut
1/4 Lockwasher
1/4 Flat Washer
3..
14
appropriate holes labeled with your
model number shown by a "
symbol.
bench top power tool and table(s).
Place a flat washer, lockwasher and nut
on the bolt. Securely tighten nut.
tool up using the drywall hole pattern
with your model number shown with a
"
". Place the drywall screws through
X
the smaller holes in the tool base and
then drive them into the wood.
Fastener Hardware
Qty.
Drywall Screws
3
3
#10 x 1-1/2" Screw
3
Washer - ID 1/4"
3
4
#8 x 1-3/4" Screw
4
4
4
#8 x 1-3/4" Screw
4
#8 x 3" Screw
4
4
#8 x 3-1/4" Screw
4
#8 x 2-3/4" Screw
b. The bench top power tool is securely
fastened to the particle board top.
c. The
combined
attached bench top power tool are
stable and will not tip.
"
Qty.
3
3
4
4
4
4
4
legstand
and
Publicidad
